QoS Shaper Setup
This screen lets you use the token bucket algorithm to allow a certain amount of large bursts of traffic while keeping most outgoing traffic at the average rate. Click Network Setting > QoS > Shaper Setup. The screen appears as shown.
Network Setting > QoS > Shaper Setup
The following table describes the labels in this screen.
Network Setting > QoS > Shaper Setup 
LABEL
Description
Add New Shaper
Click this to create a new entry.
#
This is the index number of the entry.
Status
This field displays whether the shaper is active or not. A yellow bulb signifies that this policer is active. A gray bulb signifies that this shaper is not active.
Interface
This shows the name of the Zyxel Device's interface through which traffic in this shaper applies.
Rate Limit
This shows the average rate limit of traffic bursts for this shaper.
Modify
Click the Edit icon to edit the shaper.
Click the Delete icon to delete an existing shaper. Note that subsequent rules move up by one when you take this action.
Add or Edit a QoS Shaper
Click Add New Shaper in the Shaper Setup screen or the Edit icon next to a shaper to show the following screen.
Network Setting > QoS > Shaper Setup > Add New Shaper/Edit
The following table describes the labels in this screen.
Network Setting > QoS > Shaper Setup > Add New Shaper/Edit
LABEL
Description
Active
Click this switch to enable the shaper.
Interface
Select a Zyxel Device's interface through which traffic in this shaper applies.
Rate Limit
Enter the average rate limit of traffic bursts for this shaper.
Cancel
Click Cancel to exit this screen without saving any changes.
OK
Click OK to save your changes.